Click green flag. Click on the pull station, heat sensor and/or smoke sensor to trigger the fire alarm. Caution: Loud noises and flashing lights! 237th project!
Credits to LF2021/WMF, MS54 and all. Title: Very rare original 1st generation FireSweeper system! Here is a totally original first generation FireSweeper addressable fire alarm system which comes from a small elementary school. The system was installed in May 1998 and is original to the building. It has been fully replaced with a Notifier system with BG12's and LED L-Series in August 2024 because the LCD display of the FACP failed. This system features a CP-ADR-01 fire alarm control panel, some OSD-ADR-01 (Modified Siemens/Cerberus AlgoRex DO 1131A) optical smoke detectors, a couple of HD-AD-01 (Modified Cerberus AlgoRex DT 1131A) heat detectors, a few PS-ADR-01 (Modified RSG/Simplex T-Bar) pull stations, Wheelock AS horn strobes and Wheelock SR remote strobes (No remote strobe shown in this project). All of the devices I mentioned (Apart from the AS and SR which were relased in 1995) came out in March 1998. These systems are known to activate very quickly. There's also a conventional variant of this system which is the same as this one except the panel says CP-CVT-01, the pull station doesn't have an LED and the detectors (Heat and smoke) don't have flashing LEDs. There are no multicriteria detectors as FireSweeper started using them in 2004 with their 2nd generation systems. Also, if the building needed a voice evacuation system, FireSweeper used to wire a voice control panel from another brand to the FACP. They usually use Simplex 4003 series voice control panels with Wheelock speakers and speaker strobes. Then, in 2013, FireSweeper introduced their own voice evac control panels along with their 3rd generation fire alarm systems.
