I wanted to see if I could play the entirety of BFDI 1a in Scratch, but even with compressing it beyond oblivion to 80p (it was the first 4 minutes.), it crashed half way through loading assets. So I tried a smaller scope, the first minute of BFDI 1a in 144p on Scratch. It actually turned out really well, only problem is that I had to use a forever loop because I couldn't figure out the exact number of frames without going into the project. And that the audio needed to be pitched down because Scratch was actually running the video faster than the original, and using even the lowest value on the wait second block, it would be too slow. So I sped up the audio, and had to pitch it down by 19 because it was too fast and I'm lazy to re-edit it. Will I do the rest of the first 4 minutes? Maybe. The entire episode? Doubt it. BFDI 1b? No. Same goes for the rest of the season, and the entire show. This was really made as a tech demo, and I really don't recommend watching this if you really wanna watch BFDI 1a, go watch the actual episode on YT. BFDI by Jacknjellify, New Friendly by Kevin Macleod, Project by Me. (@SonicFan123987Again) If used, give credit. Well thank you for reading the entirety of the instructions. So as a reward, here's a tip. If you prefer the audio to be pitched up (by 39), then go into the project, and there's a premade script you can run. It does have slightly better timing, but it's harder to hear some lines. Mainly Ice Cube's.