Griffon at Busch Gardens Williamsburg

Instructions

Click the grey menu bar to move through the 'Main', 'Storage', and 'Block' panel screens H: Block Layout Screen Space: Advance from Transfer Space: Dispatch from Station Right Arrow: Reverses train back into station after dispatch (if train is in the station block) Lower/ Raise Floors Manually: 1) Turn Power On 2) Press ESR Reset 3) Turn Maintenance Enable On 4) Press and hold "Up Arrow" to raise the floors Press and hold "Down Arrow" to lower the floors 5) Turn Maintenance Enable Off Power: Click Ride Start: Click Lift Start: Click Ride Stop: Click Lift Stop: Click ESR Reset: Click E-Stop: Click (once to push in twice to pull back out) Transfer Enable: Click Storage Select: Click Move Transfer: Click Train Forward: Click Train Backward: Click Start Up Procedures: 1) Click 'Power' to turn the ride on 2) Click 'ESR Reset' 3) Click 'Ride Start' 4) Click 'Lift Start' Block Check: This is an automatic feature that is required whenever trains are added or removed off of the track. Whenever the transfer is enabled, you will be required to perform a block check to ensure the train(s) safely stop at each block location. Whenever a train stops, you will see the Acknowledge light start flashing. Please acknowledge that the trains stopped accordingly. Once the block check is completed, all trains will be back at the last few brakes and operation may begin just like normal. Ghost Train: You may on occasion run into a ghost train. This is when the computer system believes a train occupy's a specific block zone, however, no train is actually there. To begin: 1) Engage emergency stop 2) Turn maintenance enable 'on' 3) Press 1,2,3,4,5,6, or 7 4) All ghost trains problems should be fixed. Adding a train to the track: 1) Ensure power is on 2) Turn 'Transfer Enable' to 'On' 3) Click selector switch to the correct storage bay 4) Press "green move transfer" button to move the transfer table 5) Press "green train forward" button to move the train forward onto the transfer table 6) Press storage selector switch until it's on 'main' 7) Press the "train forward" or "train backward" button to move the train 8) Turn 'Transfer Enable' to the "Off" position

Notes & Credits