Moxx Maintenance Checklist #32 Phase 1: Audio Stimuli & Response Prompt 1 (High Frequency): Play audio file Stimulus_A. Observe the Moxx's head tilt. If the tilt exceeds 45 degrees, mark "Unstable" on your clipboard immediately. Prompt 2 (Infrasound): Monitor the jaw servos. If the mouth begins to "chatter" rhythmically, the vocal mimicry module is attempting to synchronize. Do not speak during this phase. Phase 2: Mechanical Stabilization Eye Tracking Reset: Using your flashlight, shine a steady beam into the left optic. The Moxx should enter a "Photo-trigger" freeze state. If the pupils glow red, use the company-issued taser to reset aggressiveness to neutral. Joint Lubrication: Apply synthetic grease to the primary neck actuator. If the animatronic enters the "Hostile" state (audible growling or twitching), lower your clipboard and look away to avoid injury. Phase 3: Software & Mimicry Lockdown Vocal Box Calibration: The Moxx is known to mimic employee voices to lure technicians into a false sense of security. If the animatronic speaks your name, immediately pause the tape and wait 10 seconds for the AI to cycle out of the mimicry loop. Firmware Check: Verify the Lucie Labs.co core is not attempting to bridge with the local vent repair system. If the "Maintenance Panel" shows unauthorized access, manually reboot the office fuse box. Safety Protocol: Three-Strike Rule too many tases will render the Moxx's hardware fried, ending the maintenance session in failure.
