A sequel to my orbital test project! Behold: we now have an entire sector! But read the directions or you may not understand how to use this. INSTRUCTIONS: > SECTOR VIEW: The project first loads in Sector View with System 1 (the yellow star) autoselected. You can see which system is selected because it is displayed in the right hand corner - and its star is slightly darker than it usually is. The selected star is what will load. >System View: (In order to see how to switch into this mode, see "switching modes".) This mode shows you a view of the selected system and its major planets. You may zoom in and out of this view. >Switching Modes: Simply press the top right button labeled "system view" when in Sector View to switch into System View. When in system view, you may press a button labeled "Sector View" and located in the same location to switch back to sector view. CREDITS: Thanks to @figure8_dev for helping me come up with the orbiting pattern and for some inspiration on the zoom scripts. Thank you to @JA972222 for starting the map and motivating me to finish this! (I started a similar experiment about a week ago.) All sprites and code are by me. Also, this project uses a series of list databases to store loads of information efficiently. If you do not know how to use this particular system, comment below and I can help you.