USE: You can use this project to tell if your friends or anyone in your family has been in your room. UPDATES: Update 1.1 (11/29/2015) -Added "24-Hour Security" Mode: turning this on will have the camera recording data of motion, but will not set off the alarm. So you can do other things on your computer while running the security camera. This is useful if you usually forget to turn the security camera on. -Added pen to the "Motion Simulation" Mode and made the ball smaller. INSTRUCTIONS: •When it says, "Enter password," enter your password. (If you can't remember your password, you can always See Inside the project and show the password.) If you enter your password correctly, you will go to the main menu. If you enter your password incorrectly, the project will stop. (Just click the green flag and you can enter your password again.) •In the main menu, press M to check Motion Data. Press O to turn the Security Camera on. (It waits ten seconds before it turns on.) Press P to change your password. Press S to simulate motion from Motion Data. Press H to turn 24-Hour Security on. (It also waits ten seconds before it turns on.) •When checking Motion Data, Time of Motion tells you what the date and time was when the motion happened. Amount of Motion tells you how much motion there was. Direction of Motion tells you what direction the motion was heading. The three lists correspond with each other, so number one on the three lists will be referring to the same thing. Press D to delete all Motion Data. Press B to go back to the main menu. •Every two minutes you are in the main menu or checking Motion Data, you must enter your password again.
Remixed from rorybenjaminbricca :) Thx soo useful!
