This engine detects the FPS (frames per second) on the screen and gives everything the right speed for any fps. (please read all instructions) If you run a project at 60 FPS in Forkphorus or TurboWarp, everything speeds up double as much as intended. Things go even faster at higher framerates (Forkphorus only). This engine fixes that! When enabled, it makes everything go with the intended speed, in high FPS! If you run a project in Turbo Mode, everything in a loop speeds up to extremely fast speeds. This engine fixes that! When enabled, it makes everything go with the intended speed, in Turbo Mode! If you run a computing-intensive project on a slow computer, it could get laggy and slow down. This engine fixes that! When enabled, it makes everything go with the intended speed, when things are laggy! Try it yourself (Forkphorus): https://forkphorus.github.io/#448338071 To change FPS, scroll down to "Settings". There is an FPS adjuster there. Standard is 30, try 60, 120, 10000000, and possibly other values. To enable Turbo Mode, hold shift while clicking the flag. To simulate lag, set FPS to a low number, like 10 or 20 (Forkphorus only). In TurboWarp (above is Forkphorus), hold alt while clicking the flag for 60 FPS mode. Turn on/off the engine by clicking TurboWarp: https://turbowarp.org/448338071 Original (30/60 FPS speeds) made by @KIKOKO_ and improvement to adjust for all framerates by me (@cs3342310), use this with credit to both