/!\ WARNING! This project is HUGE! So expect laggyness while looking through the project! /!\ (Btw It's crazy fast, so if you think "Oh ThIs iS A jOkE Is'Nt It?" Nah, it just runs through all of the If than-else statements, thus creating this "Costume like" switch) To use the printer, all you have to do is change the block data from a 0 into a 1, and then it will draw a black dot in the space. It can only do 5x5, 10x10, and 15x15 so far, due to the fact that 15 pixels need 15 variables, and making 100 variables is too much, but I might give it a try after I elaborate on this one. More changes soon! ❤️ and ⭐ to give hope and joy.
I made this based off of @MaxAxel10 Morse Code Generator. I saw that when I changed the pen size, I can make it generate static, and I was amazed. I then made a copy, changed the code, and then I replaced everything because the code would either space or just not do anything. So I replaced the code and fixed it. So most inspiration is from @MaxAxel10. --------------------------Release Notes----------------------------- 12/1/2020: Released version Pre-Alpha 1.0.5. 12/1/2020: Added 15x15px print code, now can print higher-res drawings, along with tweaking a few things. Version 1.1.6 12/1/2020: Added Music because it's boring without it! Version 1.1.7 12/1/2020: Added a 3-sec wait for the choose what print so that you can listen to them nice jams. Version 1.1.8 12/2/2020: Added a little blinking animation to the 15x15 print, just to see what capabilities it can do! Version 1.1.9 12/2/2020: Made it so the 15x15 only blinks once, because it would reset and destroy the other prints that it creates for demo. Version 1.2.0
