Use it like a real elevator.
Credits to everyone, but no kirk credits. Title : EPIC MOTOR !!! Very efficient 2007 Hansen Hydraulisk MRL Roped Hydraulic Elevator… Manufacturer : Hansen Hydraulisk Hiss AB. Year : 2007. Type : MRL Roped Hydraulic, digital S3 controller with full-memory. Starter type : Solid state with soft-starter. Location : Fredsgatan 15, Arvidsjaur, Sweden. Other : This lift is TOTALLY AMAZING !!! It has a nice semi-intelligent levelling (Looks like KONE EcoDisc lifts), the pre-doors opens really early, we can close the door (By pressing the door close button) when the levelling is finished, the speed is also about 1 m/s and the starts are fast. This thing has also nice green DMG fixtures, which are very unusual, but these fixtures are very common on Hansen Hydraulisk elevators, but these buttons are very rare if the elevator is not built by Hansen Hydraulisk, Blôrk-Hissar (Hansen Hydraulik was taken over by Blôrk-Hissar in February 2007 and renamed Hansen Hydraulisk Hiss AB at the same time) or an another company which was taken over by Blôrk-Hissar or Hansen Hydraulisk. The DMG buttons are cheaper than the Dewhurst buttons and these are a bit unreliable, but these buttons are more nice-looking than any Dewhurst button. Also, nice Hansen Hydraulisk’s indicators (They made their own indicators). Also, it has a micro-levelling system and there is a silent micro-levelling motor in the GMV pump which is used for the micro-levelling on the way up. The micro-levelling is activated at the end of the deceleration and this one levels like an EcoDisc. This one has also EPIC digital S3 controllers, they doesn’t cancel calls when the safety is broken and after safety break, you need to wait a few seconds and press any floorbutton to restart the elevator. Also, these controllers are very user-friendly and very reliable and they were maybe launched in the mid-early 2000’s. Also, this thing has an awesome semi-intelligent levelling system which uses a infrared positioning system and a tachometer. The hydraulic pump and the valve are from GMV and they are controlled by a full-electronic control system which is patented by Hansen Hydraulisk Hiss AB. This system is connected to a the infrared positioning system which uses a perforated bar made with iron and an infrared sensor (Which works like an electric-eye) and the elevator knows it’s exact position, thanks to the infrared Hansen Hydraulisk’s system and the tachometer is also connected to the full-electronic control system. The Hansen Hydraulisk’s infrared positioning system works like the Lester Controls 2D Barcode Infrared Encoder which can do intelligent levelling when the Lester Controls controller is correctly set-up. Fredsgatan 15 and Fredsgatan 16 are 2 nice blocks of flats from 2007. This one is also designed to last long, the car has a proper well-built chassis and it has an EPIC MOTOR !!! The GMV T2 pump, the GMV 3010 mechanical valve (Which id electronically-controlled by the full-electronic Hansen Hydraulisk’s system) and the full-electronic control system are also very reliable as the S3 controller. In the car operating panel, there is the capacity, the year of installation, the brand and the type of the elevator drive system !!! That is very precise !!! This one has also a nice « S3 voice ». Also, nice green cabin interior, that is futuristic in my opinion !!! Hansen Hydraulisk and Blôrk-Hissar are 2 Swedish generic brands, but the quality of their elevators is REALLY REALLY GOOD !!! In Fredsgatan 16, there is an another elevator which has being built by Hansen Hydraulisk in 2007, but in 2017 this one was MODERNIZED BY JACKSON LIFT GROUP WITH GUESS WHAT LOGIC ?! LESTER CONTROLS !!!! R.IP. !!!! The Hansen Hydraulisk lift at Fredsgatan 16 (2007-2017) !!!! THANKS A LOT JACKSON LIFT GROUP FOR KILLING AN AMAZING HANSEN HYDRAULISK MRL ROPED HYDRAULIC ELEVATOR !!!! The modernized elevator :
