NOTE: turbowarp will run much faster: https://turbowarp.org/989454634 This is a face recognition program on scratch. It can take a picture and identify: eyes, mouths and noses. It does not always work and has only been tested with me, but it is more consistant than my older versions. INSTRUCTIONS: Press SPACE to take a picture and scan it for faces. Press 1 to switch to the camera. Press 2 or 3 to scan without a camera. The results you should see are: A dot under each eye. A dot under your mouth. Sometimes a dot under your nose. When your mouth is open, a dot above your mouth. You will see a few other random dots too. A further step could be used to filter these out. HELP: It is likely that it will not work for you. If this is the case, ensure: 1. Your hair is not covering your eyes. 2. Your face is about 2 feet from the camera. 3. The room you are in is well lit. 4. If you have glasses, take them off. If this does not help, then it probably does not work for a more fundemental reason.
This project works by: 1. Using a convolution kernel to scan for lines in the image. 2. Identifying areas where there are very solid lines. 3. plotting the largest of those areas as dots.